AIWA NSX-Aj14 Operating Instructions - Page 13

RECORDING AI EDIT RECORDING 6 Press w on deck 1 to start recording on the first side. CD play and recording of edited tracks for the first side start simultaneously. When the end of the tape is reached, deck 1 enters the recording stop mode. After entering the recording stop mode, go to step 7. 7 Press CD EDIT/CHECK while pressing SHIFT on the remote control to display the program for the second recording. "B" is displayed. 8 Turn over the tape in deck 1 and press w to start recording on the second side. To stop recording Press Z on deck 1. Recording and CD play stop simultaneously. The AI edit recording function enables CD recording without worrying about tape length and track length. When a CD is inserted, the unit automatically calculates the total track length. If necessary, the order of tracks is rearranged so that no track is cut short. (AI: Artificial Intelligence) To clear the edit program Press s CLEAR twice so that "EDIT" disappears on the display. To check the order of the programmed track numbers Before recording, press CD EDIT/CHECK while pressing SHIFT on the remote control to select side A or B, and press f or g repeatedly. Programmed Track number tracks number 1 Insert the tape into deck 1, and wind up to the beginning of the front side. Press Z to open the cassette holder and insert the tape with the side to be recorded on first facing out from the unit. Wind up the tape with f. 2 Press CD and load the disc(s). Tape side Program number En 3 Press CD EDIT/CHECK once while pressing SHIFT on the remote control. "EDIT" and "AI" are displayed. • When "PRGM" is displayed, press CD EDIT/CHECK while pressing SHIFT again. 4 Press DISC DIRECT PLAY 1-3 to select a disc. 5 Press numbered buttons 0-9 on the remote control to designate the tape length. 10 to 99 minutes can be specified. Example: When using a 60-minute tape, press 6 and 0. In a few seconds, the tracks to be recorded on each side of the tape are determined. • f and g are also available to designate the tape length. To add tracks from other discs to the edit program If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment. 1 Press CD EDIT/CHECK while pressing SHIFT on the remote control to select side A or B. 2 Press DISC DIRECT PLAY 1-3 to select a disc. 3 Press numbered buttons on the remote control to select tracks. A track whose playing time is longer than the remaining time cannot be programmed. 4 Repeat steps 2 and 3 to add more tracks. Time on cassette tapes and editing time The actual cassette recording time is usually a little longer than the specified recording time printed on the label. This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape's specified recording time after editing, the display shows the extra time (without a minus mark), instead of the time remaining on the tape (with the minus mark). The AI edit recording function cannot be used with discs Remaining time Programmed containing 31 tracks or more. "TR OVER" is displayed if this is of recording tracks for side A attempted. Tape length Tape side Minus mark A: First recording side B: Second recording side ENGLISH 13