ASRock X58 Extreme6 Quick Installation Guide - Page 31

2.9 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! FDD connector (33-pin FLOPPY1) (see p.2 No. 30) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.2 No. 8) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors (SATAII_1_2: see p.2, No. 13) (SATAII_3_4: see p.2, No. 14) (SATAII_5_6: see p.2, No. 15) These six Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. SATAII_5_6 SATAII_3_4 SATAII_1_2 English SATA3_5_6 SATA3_3_4 SAT3_1_2 Serial ATA3 Connectors (SATA3_1_2: see p.2, No. 10) (SATA3_3_4: see p.2, No. 11) (SATA3_5_6: see p.2, No. 12) These six Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6.0 Gb/s data transfer rate. If you install the HDD on the eSATA port on the rear I/O, the internal SATA3_6 will not function. 31 ASRock X58 Extreme6 Motherboard