Adaptec AHA-2930CU Installation Guide - Page 10
documentation for termination, Refer to your SCSI device's
 |
View all Adaptec AHA-2930CU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
2 Connect one end of an external SCSI cable to the SCSI Card 2930CU external SCSI connector. Secure the cable by tightening the thumb screws on the cable connector. Note: Avoid touching the device connector pins. 3 Connect the other end of the cable to a SCSI connector on the back of the SCSI device. 4 If you are installing only one external SCSI device, terminate the device. Refer to your SCSI device's documentation for termination instructions. 5 Connect other external SCSI devices by cabling each device to the previous one, as shown. Only terminate the SCSI device at the end of the chain. Unterminated devices Terminated device 10
-
1 -
2
-
3
-
4
-
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16
 |
 |
10
2
Connect one end of an external SCSI cable to the SCSI Card 2930CU
external SCSI connector. Secure the cable by tightening the thumb
screws on the cable connector.
Note:
Avoid touching the device connector pins.
3
Connect the other end of the cable to a SCSI connector on the back of
the SCSI device.
4
If you are installing only one external SCSI device, terminate the
device.
Refer to your SCSI device’s
documentation for termination
instructions.
5
Connect other external SCSI devices by cabling each device to the
previous one, as shown. Only terminate the SCSI device at the end of
the chain.
Terminated
Unterminated devices
device