Adaptec FS4500 User Guide - Page 22
Installing into a Rack, Use either the speednuts or cagenuts provided if
UPC - 760884144275
View all Adaptec FS4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installing the Storage Enclosure Installing into a Rack Begin the installation by ensuring that you have all these rail kit components: ■ Front rails (1 left, 1 right) ■ Rear rails, two different sizes (2 left, 2 right) ■ Two sizes of screws (10 large, 4 small) ■ Two types of nuts (10 of each) To install your Storage Enclosure in a rack: 1 Secure the front rails to the front supports of the rack, using the supplied screws, as shown in Figure 2-1. Note: Use either the speednuts or cagenuts provided if your rack does not have threaded holes. Figure 2-1 Securing the Rails to the Rack 2 Check the length between the front and rear supports of your equipment rack and determine which set of rear rails to use, the long or the short. 2-4
2-4
Installing the Storage Enclosure
Installing into a Rack
Begin the installation by ensuring that you have all these rail kit
components:
■
Front rails (1 left, 1 right)
■
Rear rails, two different sizes (2 left, 2 right)
■
Two sizes of screws (10 large, 4 small)
■
Two types of nuts (10 of each)
To install your Storage Enclosure in a rack:
1
Secure the front rails to the front supports of the rack, using the
supplied screws, as shown in
Figure 2-1
.
Note:
Use either the speednuts or cagenuts provided if
your rack does not have threaded holes.
Figure 2-1
Securing the Rails to the Rack
2
Check the length between the front and rear supports of your
equipment rack and determine which set of rear rails to use, the
long or the short.