Alpine IVA W205 User Manual - Page 38

Setting the VISUAL Soft Button Setting item: VISUAL KEY Setting contents: VISUAL / NAV. VISUAL: Recalls the VISUAL selection screen by touching [VISUAL]. NAV.: Switches directly to the navigation screen by touching [VISUAL]. Setting the VISUAL Button on the Unit The unit's VISUAL button function can be changed. Setting item: CUSTOMISE KEY Setting contents: AUDIO SETUP / SAT / TEL AUDIO SETUP: Pressing and holding VISUAL for at least 2 seconds will recall the AUDIO SETUP screen. SAT: If you press and hold VISUAL for at least 2 seconds when either the XM or SIRIUS Receiver Box is connected, the Weather or Traffic channels will be recalled. TEL: If you press and hold VISUAL for at least 2 seconds when the Bluetooth Box is connected, the Bluetooth TEL screen will be recalled. Setting the Digital Output To connect an audio processor using the optical digital output, set to "ON" by the following procedure. Setting item: OPTICAL OUT Setting contents: OFF / ON • Afterwards, set ACC to OFF once, then turn it ON again. The setting of Digital Output is decided. Subwoofer On and Off Setting item: SUBWOOFER Setting contents: OFF / ON OFF: Subwoofer output is off. ON: Subwoofer output is on. DISPLAY Setup Display Setup Operation To display the Display mode screen: To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below. 1 Bring your vehicle to a complete stop at a safe location. Engage the parking brake. 2 Keep pushing the foot brake and release the parking brake once then engage it again. 3 When the parking brake is engaged for the second time, release the foot brake. • For automatic transmission vehicles, place the transmission lever in the Park position. Now, the locking system for the Display mode operation has been released. Engaging the parking brake can reactivate the Display mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3) of "To display the Display mode screen." Each time the ignition is turned OFF, perform the procedure of "To display the Display mode screen." The following steps 1 to 4 are common operations to each "Setting item" of DISPLAY Setup. Refer to each section for details. 1 Touch [SETUP] on the main source screen. The SETUP selection screen is displayed. 2 Touch [DISPLAY]. The DISPLAY SETUP screen appears. 3 Touch [ ], [ ] or [ ] etc., of the desired item to change its setting. Setting items: VISUAL EQ / DIMMER / DIMMER LOW LEVEL / BACKGROUND / AUTO BACKGROUND / DATA DOWNLOAD / BASE COLOR / PULSETOUCH / SCREEN ALIGNMENT 4 Touch [RETURN] to return to the previous screen. Touch and hold [RETURN] for at least 2 seconds to return to the main source screen that was displayed before the setup operation was started. • Immediately after changing the settings of Display Mode (While the system is writing data automatically) do not turn the ignition key (engine key) to OFF. Otherwise, the settings may not be changed. 37-EN