Alpine PSS-22WRA Owners Manual - Page 15
Rear Sound Bar Speaker Installation 2011 - 2014 Models continued, Rear Sound Bar Speaker
View all Alpine PSS-22WRA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Jeep Wrangler UNLIMITED JK • 15/19 Rear Sound Bar Speaker Installation 2011 - 2014 Models (continued) 7 Clean the factory grille surface and apply the Alpine Badges. 8 Align the factory speaker grille over the tweeter bridge grille adapter tabs, connect the vehicle plug to the speaker and mount to the sound bar using the (3) T15 Torx screws. Rear Sound Bar Speaker Installation 2015 - 2018 Models 1 Press the tweeter into the 3.5" tweeter adapter. 2 Select the (2015-2018) crossover input wires and connect to the vehicle plug. Connect tweeter connectors. Secure the crossover. Note: 2011-2014 input plug is not used. 3 Cut a slit in the center of the polyfill, and pull the vehicle plug through. then insert the excess polyfill into the sound bar enclosure. Note: Installation of polyfill is needed for optimum sound. TW level +3db TW level 0db (-) (+) (+) (2015-2017) Do not use 2007-2014 Connect the tweeter (-) to the crossover and select either: 0db wire (Default TW level) or +3db wire (Increased TW level) for the tweeter (+) lead 4 Add the foam strip, connect the vehicle plug to the speaker. 1. Install using the reverse procedure 2. Repeat for the opposite side Add foam strip (included) Insert Polyfill