Apple MA261Z/A User Manual - Page 175

IV Marking Controls Use these controls to set In and Out points for a clip on tape. Clip In Point Timecode field Go to In Point Clip Out Point Timecode field Go to Out Point Mark In Mark Out  Mark In (I): This sets the In point for a clip on tape.  Clip In Point Timecode field: Shows the timecode value of the currently set In point.  Go to In Point: This causes the connected VTR to cue to the currently set In point.  Mark Out (O): This sets the Out point for a clip on tape.  Clip Out Point Timecode field: Shows the timecode value of the currently set Out point.  Go to Out Point: This causes the connected camcorder or VTR to cue to the currently set Out point. Capture Tab The Capture tab is where you enter all of the descriptive information about a clip before you capture it. Entering descriptive information about a clip is also known as logging. Capture Bin Controls Use the Capture Bin controls to choose where clips are stored when you capture them. The Capture Bin button contains the name of the currently selected capture bin. Up New Bin  Capture Bin: This button contains the name of the bin in your project where logged clips for captured media are stored. There can be only one capture bin at a time, no matter how many projects are open. When you click this button, the bin opens in its own window; if the bin is already open, that window moves to the front.  Up: Click to move the capture bin up a level from the currently selected bin. For example, you could switch from a bin to the bin that contains it. If the current capture bin is at the highest level, clicking this button assigns the project itself as the capture bin.  New Bin: Click this to create a new bin inside the currently selected bin, and set it as the capture bin. Chapter 14 Capturing Your Footage to Disk 175