Apple MA261Z/A User Manual - Page 183

IV 8 Navigate to the first frame of the clip you want to capture by doing one of the following: Â Use the transport controls. Â Enter a timecode value in the Current Timecode field. Enter the In point timecode here. Enter the Out point timecode here. For more information about controls in the Capture window, see "Overview of the Capture Window" on page 172. 9 To set the In point for the clip, do one of the following: Â Click the Mark In button. Â Press I. 10 Find the last frame of the clip you want to capture by doing one of the following: Â Use the transport controls. Â Enter a timecode value in the Current Timecode field. 11 To set the Out point for the clip, do one of the following: Â Click the Mark Out button. Â Press O. When you set an In or Out point, you may be off by a few frames. You can adjust the clip In and Out points using timecode. 12 To adjust clip In and Out points using timecode, do one of the following: Â Enter a timecode number for the In or Out point. Â Click in the Clip In or Out point timecode field, then type + (plus sign) or - (minus sign) followed by the number of frames or seconds you want to adjust the In or Out point. For example, you could adjust the In point to be 10 frames earlier by clicking in the Clip In Point Timecode field and then typing -10. Important: You should avoid capturing a clip if you see timecode breaks (where timecode numbers skip or disappear) between the clip In and Out points (for example, if the timecode starts over at 00:00:00:00 in the middle of the tape). For more information, see "Avoiding Duplicate Timecode Numbers on a Single Tape" on page 195. Chapter 14 Capturing Your Footage to Disk 183