Asko D5644 User manual 8094451 Asko D5644 XLCS EN - Page 9
Selecting Options, Start The Dishwasher, Time Remaining
View all Asko D5644 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Mixed wash This dishwashing program is used when you have lightly soiled dishes in the upper basket and heavily soiled dishes in the lower basket. This program adds a prewash and has a longer program time than Lower half. Rinse & Dry This program consists of a rinse with heating and drying. This is a suitable program if, for example, you plan to make jam and want to rinse and heat clean glass jars. Rinse & Hold Use to rinse dishes while you wait for the dishwasher to become fully loaded. SELECTING OPTIONS To select an option, press one of the option buttons. The field under the button lights when the option is activated. The available options depend on the selected program. Once you have started the program, the options you selected are saved for the next time you use the same program. An exception is the Delayed start option. High temperature Activate this option for improved dishwashing results. The machine then uses a higher temperature for the main wash. If you want to use the lower temperature, press again so that the field under the button turns off. You can vary the temperature as shown below: Heavy wash: 140 °F (60 °C) / 160 °F (70 °C) Normal wash: 115 °F (45 °C) / 150 °F (65 °C) Daily wash: 140 °F (60 °C)/150 °F (65 °C) Quick wash: 85 °F (30 °C) / 140 °F (60 °C) Super Quick: 85 °F (30 °C) / 140 °F (60 °C) Delicate wash: 105 °F (40 °C) / 120 °F (50 °C) Eco wash: 120 °F (50 °C) / 140 °F (60 °C) Upper half: 130 °F (55 °C) / 150 °F (65 °C) Lower half: 130 °F (55 °C) / 150 °F (65 °C) Mixed wash: 130 °F (55 °C) / 150 °F (65 °C) Long dry A higher temperature in the final rinse and a longer drying phase improves the drying result if you activate the Long dry option. This causes a slight increase in energy consumption. This option can be used with all programs except Time program, Rinse & Dry, and Rinse & Hold. If you want a program with Short dry, press again so that the field under the button turns off. Delayed start When you select Delayed start, the dishwasher will start 1-24 hours after you press the Start/Stop button. 1 Press the button once to activate Delayed start. Press the button several times - or hold it in - to set the desired number of hours. 2 Press Start/Stop and the dishwasher counts down 1 hour at a time and starts after the selected delay. Press and hold Start/Stop for three seconds if you want to cancel the Delayed start option. NOTE! Remember to press the Start/Stop button to start the program. Set time Press the option button several times - or hold it in - to set the desired program time for Time program. You can choose a program time between 30 minutes and 3 hours. START THE DISHWASHER Press and hold Start/Stop until the display shows (the door open symbol). This indicates that the dishwasher is ready to start. Close the door properly, otherwise the dishwasher will not start. The display flashes three times with the remaining time to indicate that the program has started. NOTE! If the machine does not start within 2 minutes of the last button press, the display returns to showing the last program run. TIME REMAINING Once you have selected a program and options, the display indicates how long the program took the last time it was used. Once you have started the dishwasher, the display indicates how much program time remains. The remaining time is updated after the water for the final rinse has been heated. This may differ somewhat from time to time depending on the temperature of the water supply, the amount of dishes, the ambient temperature, and other factors. While the program is running, the time counts down and the remaining program time is shown on the display. The remaining time is shown, for example, as 1:15, which means the program will run for another 1 hour and 15 minutes. Customer Care Center 1-800-898-1879 www.askousa.com 9