Asko W4114CW Use and Care Guide English - Page 14

CONNECTING TO THE POWER MAINS Connection upon delivery After installation, the washing machine should stand still for two hours before it is connected to the power mains. Connect the appliance to a grounded power outlet. After installation, the wall outlet should be freely accessible. The outlet should be fitted with a grounded contact (in compliance with the relevant regulations). TYPE: WMXX.XXXXX MODEL: XXXXXX.X Art.No.: XXXXXX/XX Ser.No.: XXXXXXXX XXX-XXX V ~ XXXX W X kg XXA IPX4 XX Hz XX-X MPa Information about your washing machine is indicated on the rating (type) plate. Use the type A differential current protection switch. Electrical Connections The machine is delivered ready-fitted with a plug and is intended for connection to an ASKO Dryer, which is equipped with a matching receptacle. The plug supplied with the washer can only be used with an ASKO Dryer. If the washer is used separately or with another dryer, it must be on a separate 208-240 V single-phase circuit. If the machine is to be used in a wet area, the supply must be protected by a residual current device. As supplied: 208-240 V, 60 Hz, 2000W heating element, 15A fuse required. We recommend using over-voltage protection to protect the appliance in case of a lightning strike. The washing machine may not be connected to the power mains using an extension cord. Do not connect the washing machine to an electrical outlet intended for an electric shaver or hair dryer. Any repair and maintenance pertaining to safety or performance should be done by trained experts. Connection to a permanently wired supply point must be made only by a qualified electrician. To reduce the risk of fire, electric shock, or injury to persons, read the chapter "IMPORTANT SAFETY INSTRUCTIONS" before operating this appliance. 14 Customer Care Center, 1-800-898-1879, www.askona.com