Asus AGP-V3000 User Manual - Page 17

IV. Microsoft Windows NT IMPORTANT! • Windows NT 3.5x does not support AGP cards. • Before installing the ASUS AGP-V3000 display driver in Windows NT 4.0, make sure that you have installed Windows NT 4.0 Service Pack version 3.0 (available on the Internet at http://www.microsoft.com/isapi/support/ bldqpage.idc?ProductPage=q_servpk). Otherwise, the system will hang and will not be able to start up! • For all the AGP features to be available you must be using Windows NT 5.0 (available in the future) Installation Procedures 1. Start Windows NT, switch display properties to VGA mode (16 colors, 640 x 480 pixels), then restart your computer to make the change. 2. After your computer restarts, right-click the desktop and click Properties. 3. Click the Settings tab. 4. Select Change Display Type. 5. Select Adapter Type and click Change. 6. Click Have Disk. 7. Insert the ASUS AGP-V3000 Installation CD. 8. Type D:\NT40 (assuming your CD-ROM disc drive is in drive D) or click Browse to select the path of the display driver for Windows NT. Click OK. 9. You will see a list of ASUS AGP-V3000 drivers. Select ASUS AGP-V3000 and then click OK. 10. Windows NT will once again prompt for confirmation. All appropriate files are then copied to the hard disk.When all files are copied, go back to the Display Properties box by clicking Close. Click Apply. 11. The System Settings Change dialog box is displayed. Click Yes to restart Windows. 12. Windows NT will restart with the default settings. The Display applet will appear to allow for mode selection. iV. Windows NT Driver Installation ASUS AGP-V3000 User's Manual 17