Asus P1-PH1 User Guide - Page 33
ASUS Pundit P1-PH1 system, Serial ATA - pundit power supply
View all Asus P1-PH1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
To install a Serial ATA hard disk drive: 1. Follow steps 1-3 of the previous section. 2. Connect one end of the supplied 7-pin SATA cable to the connector at the back of the Serial ATA cable drive, then connect the other end to the SATA connector on the motherboard. See page 4-7 for the location of the Serial ATA connector. 3. For Serial ATA HDDs with a 4-pin power connector: Connect a 4-pin (female) power plug from the power supply unit (PSU) to the 4-pin (male) power connector at the back of the drive. For Serial ATA HDDs without a 4-pin power connector: Use the supplied SATA power cable. Connect a 4-pin plug (female) from the PSU to the 4-pin (male) plug of the SATA power cable. Connect the 15-pin SATA power plug to the power connector at the back of the drive. 15-pin 4-pin (male) Serial ATA power cable ASUS Pundit P1-PH1 system 2-17