Asus P5V-VM SE DH P5VD2-VM English Edition User''s Manual - Page 108

Repairing a Mirror conflict A Mirror conflict occurs when one or both disks in a RAID 1 (Mirror) configuration are unplugged from the system, then plugged in again. Since both disks contain exactly the same data, the system will be unable to determine which of the two is the source drive. This option allows you to set the source drive and rebuild the Mirror drive according to the contents of the source drive. To repair a Mirror conflict: 1. In the main JMB363 RAID BIOS menu, highlight Repair Mirror Conflict using the up/down arrow key then press . [Main Menu] Create RAID Disk Drive Delete RAID Disk Drive Revert HDD to Non-RAID Repair Mirror Conflict Save and Exit Setup Exit Without Saving 2. Use the space bar to select the HDD that you want to set as source drive. The selected HDD shows a sign before it. 3. Using the , move to the RAID Disk Drive List menu and highlight the RAID set that you want to rebuild. Press to begin rebuilding the Mirror configuration. A status bar at the bottom of the screen shows the progress of the rebuilding. JMicron Technology Corp. [Main Menu] Create RAID Disk Drive Delete RAID Disk Drive Revert HDD to Non-RAID Repair Mirror Conflict PCI-to-SATA II/IDE RAID [Hard Disk Drive List] Model Name HDD0: HDS722516VLSA80 HDD1: HDS722516DLA380 Controller BIOS v0.97 Capacity 164 GB 164 GB Type/Status RAID Inside RAID Inside Save and Exit Setup Exit Without Saving [RAID Disk Drive List] Model Name RDD0: JRAID RAID Level 1-Mirror Capacity XXX GB Status Rebuild Members(HDDx) 01 3-18 Rebuilding... 01%, please wait... Chapter 3: Software support