Asus RS100-X7 PI2 User Guide - Page 49
VGA controller setting 3-pin VGA_SW1, CPU Fan and Chassis Fan control setting, pin CPUFAN_SEL1,
View all Asus RS100-X7 PI2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
2. VGA controller setting (3-pin VGA_SW1) This jumper allows you to enable or disable the onboard VGA controller. Set to pins 1-2 to activate the VGA feature. P8B-X/MR P8B-X/MR VGA setting 3. CPU Fan and Chassis Fan control setting (3-pin CPUFAN_SEL1, CHAFAN_SEL1) These jumpers allow you to switch for fan pin selection. The CPUFAN_SEL1 jumper is for the CPU fans control and the CHAFAN_SEL1 jumper is for the front fans and rear fans control. Set to pins 1-2 when using 4-pin fans or pins 2-3 when using 3-pin fans. P8B-X/MR P8B-X/MR FAN setting • If you use a 4-pin fan but set the jumper to pin 2-3, the fan you installed may not work. • If you use a 3-pin fan but set the jumper for a 4-pin fan, the fan control will not work and the fan you installed will always run at full speed. ASUS RS100-X7 4-5