Asus T2-PH1 User Guide - Page 39
Installing a floppy disk drive
UPC - 610839552757
View all Asus T2-PH1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
2.9 Installing a floppy disk drive The barebone system comes with one 3.25-inch drive bay for a floppy disk drive. To install a floppy disk drive: 1. Remove the front panel cover. For instructions on how to remove the front panel cover, refer to steps 1-5 of section "2.8 Installing an optical drive." 2 2. Carefully insert the floppy disk drive into the floppy drive bay until the screw holes align with the holes on the bay. 3. Secure the floppy disk drive with two screws. 33 4. Connect the floppy disk drive signal cable to the signal connector at the back of the drive. 5. Connect the other end of the signal cable to the floppy disk drive connector (labeled FLOPPY) on the motherboard. See page 4-13 for the connector location. 6. Connect a power cable from the power supply unit to the power connector at the back of the floppy disk drive. See page 2-24 for details on the power supply unit plugs. ASUS T2-PH1 6 4 2-19