Asus V2-AE1 User Guide - Page 72
with a jumper cap. Remove the jumper caps only when you intend
View all Asus V2-AE1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
8 . Front panel audio connector (10-1 pin FP_AUDIO) This connector is for a chassis-mounted front panel audio I/O module that supports AC'97 audio standard. AGND +5VA BLINE_OUT_R BLINE_OUT_L ® Front audio connector FP_AUDIO MIC2 MICPWR Line out_R NC Line out_L 9 . Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS +5VSB_MB Chassis Signal GND ® Chassis intrusion connector (Default) 4-10 Chapter 4: Motherboard info