Behringer ULTRAZONE ZMX8210 Manual - Page 7
Application
View all Behringer ULTRAZONE ZMX8210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ULTRAZONE ZMX8210 In case you need to use further signals, simply link to units together. The ZMX8210 can handle line-level sources, dynamic microphones and phantom-powered capacitor microphones as input signals. Fig. 2.4: Connections of the ZMX8210 [24] INPUTS 7 - 8: Unbalanced signal inputs for channels 7 - 8. The connections are RCA connectors. [25] INPUTS 1 - 6: Balanced signal inputs for channels 1 - 6. 3. Application The ZMX8210 is a user-friendly rack mixer which is principally used for fixed installations to direct public address in different zones or facilities, such as cafés, practices and houses of worship. With one unit, you can provide a maximum of three zones with different signals. 3.1 Examples of application In comparison to conventional rack mixers, the ZMX8210 offers several advantages for fixed installations and PA equipment that is being used by laymen. With the Euro-type connectors and the easy usability, the ZMX8210 optimally fulfills the requirements of these kind of applications. 3.1.1 Directing public address to up to three zones The following application example shows a typical cabling of three zones in mono mode. Distribute the signal to zones 1 - 3 by using the routing switches (L, R, AUX) of the particular input channel. Instead of three independent mono zones, it is also possible to have one stereo zone (LEFT / RIGHT bus) and one mono zone (AUX bus). Fig. 3.1: Example of using three zones 3.1.2 Using multiple ZMX8210s In case the eight input channels of the ZMX8210 are not enough, you can link two units together by using the BUS LINKS connectors. The output buses of the two units are connected by routing the input signals of both units to the output buses. This gives you additional inputs. The output signal can be on both units. To use two units together, please complete the following steps: 1) Set one unit to master mode and the second to slave mode by using the SLAVE/MASTER switch [22]. 2) Using a shielded, 4-pin conductor cable to connect the BUS LINKS connector of the MASTER unit to the corresponding connector of the SLAVE unit. 3.1.3 Remote control of the ZMX8210 The ZMX8210 provides a 5-pin REMOTE connector to remote control == the volume level of the LEFT and RIGHT buses. == channel selection of channels 7 and 8. The remote control can be realized by using simple components. Volume level of the LEFT and RIGHT buses To be able to remote control the volume level of the LEFT and RIGHT buses, you need a potentiometer. Use a == 10 kΩ potentiometer to achieve a maximum attenuation of 30 dB. == 100 kΩ potentiometer to achieve a maximum attenuation of 60 dB. Application 7