Behringer X32-TP Quickstart Guide - Page 8
Using Busses
View all Behringer X32-TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Using Busses Bus Terminology Explained: Unlike other consoles, the X32 uses ONLY Busses for Sends (no AUX Sends). You can use these 16 busses for whatever you require, FX sends, Monitor sends, Sub Groups, etc. Bus Setup: The X32 offers ultra flexible busing as each channels' bus sends can be independently Pre or Post Fader, (selectable in pairs of buses). Select a channel and press "view" in the BUS SENDS section on the channel strip. Reveal options for Pre / Post / Subgroup by pressing the LAYER Down button by the screen. To configure a bus globally, press its' select button and then press "view" near the CONFIG / PREAMP section on the channel strip. Use the third rotary encoder to change configurations. This will affect all channel sends to this bus. Note: Mix buses can be linked in odd-even adjacent pairs to form stereo mix buses. To link buses together, select one and press the "view" button near the CONFIG/PREAMP section of the channel strip. Press the first encoder to link. When sending to these buses, the odd BUS SEND encoder will adjust send level and even BUS SEND encoder will adjust pan/balance.