Belkin F5L049 User Manual - Page 55

information Table of Contents sections 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 IMPORTANT NOTE: Radiation Exposure Statement This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This device has been designed to operate with an antenna having a maximum gain of 2 dB. An antenna with a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 Ohms. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that permitted for successful communication. Europe - EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/ EC.The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive 1999/5/EC: EN60950-1: 2006: Safety of Information Technology Equipment EN50385: 2002-08: Product standard to demonstrate the compliance of radio base stations and fixed terminal stations for wireless telecommunication systems with the basic restrictions or the reference levels related to human exposure to radio frequency electromagnetic fields (110MHz-40GHz) - General public EN 300 328 V1.7.1: 2006-10: Electromagnetic compatibility and radio spectrum matters (ERM); wideband transmission systems; data transmission equipment operating in the 2.4GHz ISM band and using spread spectrum modulation techniques; harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive EN 301 489-1 V1.8.1: 2008: Electromagnetic compatibility and radio spectrum matters (ERM); electromagnetic compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements EN 301 489-17 V1.3.2: 2008: Electromagnetic compatibility and radio spectrum matters (ERM); electromagnetic compatibility (EMC) standard for radio equipment and services; Part 17: Specific conditions for 2.4GHz wideband transmission systems and 5GHz high-performance RLAN equipment This device is a 2.4GHz wideband transmission system (transceiver), intended for use in all EU member states and EFTA countries, except in France and Italy where restrictive use applies. In Italy the end user should apply for a license at the national spectrum authorities in order to obtain authorization to use the device for setting up outdoor radio links and/or for supplying public access to telecommunications and/or network services. This device may not be used for setting up outdoor radio links in France and, in some areas, the RF output power may be limited to 10mW EIRP in the frequency range of 2454-2483.5MHz. For detailed information, the end user should contact the national spectrum authority in France. Open Source Software This product contains software that is licensed under the GNU General Public License (GPL). The corresponding source code is available on the Belkin Open Source website, http://www.belkin.com/support/opensource/. You can also obtain a physical copy of the source code upon request at http://www.belkin.com/support/ opensource/. There may be a small charge applied for the physical copy. The source code that can be found at the website and that is physically distributed is complete to the best of Belkin's knowledge. If you believe any additional (or different) source code should be provided under the GPL, please contact Belkin at http://www.belkin.com/support/opensource/ and provide in detail the product part number, version number, firmware version number, and the name of the code module in question. Belkin is committed to meeting the requirements of the GPL and of any open source licenses and will make all required source code available. For more information on the GPL, please go to http://www.gnu.org/licenses/ licenses.html. A copy of the full GPL License is included on the setup CD. (Open My Computer, right-click on your CD/DVD drive, and select "Explore", e.g., D:\GPL License.txt.) Home Base 53