BenQ LX60ST Laser DLP Projector LX60ST and LW61ST User Manual - Page 25

If you forget the password If the password function is activated, you will be asked to enter the six-digit password every time you turn on the projector. If you enter the wrong password, the Password Error password error message as pictured to the right is Please try again. displayed lasting for 3 seconds, and the INPUT PASSWORD message follows. You can retry by entering another six-digit password, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure. See "Entering the password recall procedure" on page 25 for details. If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a short time. Entering the password recall procedure 1. Press and hold AUTO on the projector or remote control for 3 seconds. The RECALL PASSWORD projector will display a coded number on the screen. 2. Write down the number and turn off your Please write down the recall code, and contact BenQ Customer Center. projector. Recall Code: 0 2 1 2 3. Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase MENU Exit documentation to verify that you are an authorized user of the projector. Changing the password 1. Open the OSD menu and go to the SYSTEM SETUP: Advanced> Security Settings > Change Password menu. 2. Press MODE/ENTER. The message "INPUT CURRENT PASSWORD" appears. 3. Enter the old password. i. If the password is correct, another message "INPUT NEW PASSWORD" is displayed. ii. If the password is incorrect, the password error message is displayed lasting for three seconds, and the message "INPUT CURRENT PASSWORD" is displayed for your retry. You can press MENU/EXIT to cancel the change or try another password. 4. Enter a new password. IMPORTANT: The digits being input will be displayed as asterisks on-screen. Write your selected password down here in this manual in advance or right after the password is entered so that it is available to you should you ever forget it. Password Keep this manual in a safe place. 5. Confirm the new password by re-entering the new password. 6. You have successfully assigned a new password to the projector. Remember to enter the new password next time the projector is started. 7. To leave the OSD menu, press MENU/EXIT. Operation 25