Bernina 717 Manual - Page 9
Inserting, bobbin
View all Bernina 717 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Inserting the bobbin Draw the thread from the spool round tension (9) and from there - as shown in picture - guide it to the mounted bobbin case. Start the motor by pressing on the foot starter. As soon as there Is enough thread wound, stop motor, remove the bobbin case and push the bobbin winder spindle again to theleft.Re-tighten releasescrew on the hand wheel. a Insertion of bobbin into the bobbin case. When the bobbin is in the case make sure that the thread unwinds in the direction of the arrow. Draw thread through slot and then under tension spring. Do not hold the bobbin. The bobbin must turn in the direction of the arrow when unwinding. Insertion of the bobbin case into the hook. Raise needle to top position by turning the handwheel. As when removing the bobbin case hold it by the hinged latch with thumb and forefinger of the left hand. Hold bobbin case in such a way that the extension arm is directed upwards and fits into the niche of the hook race cover. Check-up : Pull end of thread.