Binatone Focus 360 User Guide - Page 13

2.3 Monitor Unit Power Supply ENGLISH IMPORTANT Installing the rechargeable battery pack and charging it fully before use is recommended. This will allow the unit to operate on battery in the event of a power failure. 1. Connect the small plug of the power adapter to the Monitor unit and the other end to the electrical outlet. Only use the enclosed power adapter (6V DC/500mA). 2. Press and hold the P POWER ON/OFF button for 1 second to turn ON the Monitor unit. 3. Once the Camera and Monitor units are switched on, the display on the Monitor unit will show the video captured by the Indoor Camera Unit. 4. If there is no connection or you are out of range, the video display will go off and will be shown on the LCD display, and the unit will beep every 5 seconds. Move the Monitor unit closer to the Indoor Camera Unit until the link is re-established. 5. Press and hold the P POWER ON/OFF button, until the progress bar finishes scrolling, to turn OFF the Monitor unit. NOTE The battery icon 0 turns RED to indicate that the battery is low, and it gives a beep every 16 seconds. The battery needs to be recharged. The battery pack takes about 16 hours to be fully charged. When charging 1. During power OFF, when adapter is plugged in, an adapter logo will display on screen and then a flashing battery logo will display for 45 sec. The Blue LED at top left corner light up indicates that the adapter is plugged in. Getting Started 13