Biostar GF7050V-M7 Setup Manual - Page 25

Award Beep Code Extra Informat Ion - beep codes

Get Biostar GF7050V-M7 PDF manuals and user guides View all Biostar GF7050V-M7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

GF7050V-M7 5.2 AWARD BIOS BEEP CODE Beep Sound One long beep followed by two short beeps Meaning Video card not found or v ideo card memory bad High-low siren sound CPU overheated System will shut down automatically One Short beep when system boot-up No error found during POST Long beeps every other second No DRAM detected or install 5.3 EXT RA INFORMAT ION CPU Overheated If the system shutdown automatically after power on system for seconds, that means the CPU protection function has been activated. When the CPU is over heated, the motherboard will shutdown automatically to avoid a damage of the CPU, and the system may not power on again. In this case, please double check: 1. The CPU cooler surface is placed evenly with the CPU surface. 2. CPU fan is rotated normally. 3. CPU fan speed is fulfilling with the CPU speed. After confirmed, please follow steps below to relief the CPU 0protection function. 1. Remove the power cord from power supply for seconds. 2. Wait for seconds. 3. Plug in the power cord and boot up the system. Or you can: 1. Clear the CMOS data. (See "Close CMOS Header: JCMOS1" section) 2. Wait for seconds. 3. Power on the system again. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
GF7050V-M7
23
5.2
A
WARD
BIOS
B
EEP
C
ODE
Beep Sound
Meaning
One long beep followed by two short
beeps
Video card not found or video card
memory bad
High-low siren sound
CPU overheated
System will shut down automatically
One Short beep when system boot-up
No error found during POST
Long beeps every other second
No DRAM detected or install
5.3
E
XTRA
I
NFORMAT ION
CPU Overheated
If the system shutdown automatically after power on system for
seconds, that means the CPU protection function has been activated.
When the CPU is over heated, the motherboard will shutdown
automatically to avoid a damage of the CPU, and the system may not
power on again.
In this case, please double check:
1.
The CPU cooler surface is placed evenly with the CPU surface.
2.
CPU fan is rotated normally.
3.
CPU fan speed is fulfilling with the CPU speed.
After confirmed, please follow steps below to relief the CPU
0protection function.
1.
Remove the power cord from power supply for seconds.
2.
Wait for seconds.
3.
Plug in the power cord and boot up the system.
Or you can:
1.
Clear the CMOS data.
(See “Close CMOS Header: JCMOS1” section)
2.
Wait for seconds.
3.
Power on the system again.