Bissell Pet Hair Eraser® Vacuum 87B43 User Guide - English - Page 7

Notice, Caution

Get Bissell Pet Hair Eraser® Vacuum 87B43 PDF manuals and user guides View all Bissell Pet Hair Eraser® Vacuum 87B43 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Operations Power switch The Power Switch is located just below the handle on the front of the vacuum. Push the rocker switch "ON" (I) to vacuum, and "OFF" (O) when cleaning is complete. Handle positions Press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions. 1. Upright - For storage and above floor cleaning with tools. 2. Normal Cleaning - Press handle release pedal once. Position used for most household floor cleaning tasks. 3. Low Cleaning - With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, chairs or beds. Height adjustment There are seven height settings available for various floor surfaces. Turn the dial on the foot of the cleaner to the desired setting. Lowest setting - For low pile carpet or bare floors. To pick up debris it may be necessary to move up one setting. Medium settings - For medium pile carpet. High setting - For high pile and most shag carpet. Note: For optimal carpet cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. If the dial is difficult to turn, tilt the cleaner back slightly to take the weight off the foot while turning. Pet Hair Lifter Use to pick up pet hair from carpeted surfaces. Just vacuum like you normally would. The vacuum will grab pet hair when you pull back and it will release hair and suction it up when you push forward. NOTE: Turn vacuum off before you flip up or flip down the Pet Hair Lifter. www.bissell.com CAUTION: Before using your vacuum, make sure that the dirt container is in the locked position and that all filters (premotor and HEPA post-motor) are in place. Do not operate your vacuum without these filters. 1. 2. 3. Tip: Before cleaning under low furniture, check area first for objects that might harm the unit or block the vacuum hose. CAUTION: To avoid personal injury and to prevent the cleaner from falling when cleaning stairs, always place it at the bottom of the stairs. NOTICE: For above floor cleaning, the floor brush will continue to rotate but is raised above floor. To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward. 7 800.237.7691

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Power switch
The Power Switch is located just
below the handle on the front of the
vacuum. Push the rocker switch “ON”
(I) to vacuum, and “OFF” (O) when
cleaning is complete.
Handle positions
Press the handle release pedal, located
on the lower left side of the vacuum,
with your foot to place your vacuum
into one of three cleaning positions.
1.
Upright –
For storage and above floor
cleaning with tools.
2.
Normal Cleaning –
Press handle
release pedal once. Position used for
most household floor cleaning tasks.
3.
Low Cleaning –
With the vacuum in
normal cleaning position, press handle
release pedal again. Use for reaching under
low furniture such as tables, chairs or beds.
Height adjustment
There are seven height settings available for
various floor surfaces. Turn the dial on the
foot of the cleaner to the desired setting.
Lowest setting – For low pile carpet or
bare floors. To pick up debris it may
be necessary to move up one setting.
Medium settings – For medium pile carpet.
High setting – For high pile and most
shag carpet.
Note: For optimal carpet cleaning
performance, adjust to the lowest
practical setting. If your cleaner is
difficult to push, adjust to the next
higher setting.
If the dial is difficult to turn, tilt the
cleaner back slightly to take the
weight off the foot while turning.
Pet Hair Lifter
Use to pick up pet hair from carpeted
surfaces. Just vacuum like you normally
would. The vacuum will grab pet hair
when you pull back and it will release hair
and suction it up when you push forward.
NOTE: Turn vacuum off before you
flip up or flip down the Pet Hair Lifter.
www.bissell.com
800.237.7691
7
O
perations
NOTICE:
For above floor cleaning, the
floor brush will continue to
rotate but is raised above floor.
To prevent carpet damage, do
not lean on the vacuum or let
the powerfoot tilt forward.
CAUTION:
To avoid personal injury
and to prevent the cleaner
from falling when cleaning
stairs, always place it at the
bottom of the stairs.
CAUTION:
Before using your vacuum,
make sure that the dirt con-
tainer is in the locked posi-
tion and that all filters (pre-
motor and HEPA post-motor)
are in place. Do not operate
your vacuum without these
filters.
Tip:
Before cleaning under low furni-
ture, check area first for objects
that might harm the unit or block
the vacuum hose.
1.
2.
3.