Bosch HDI8056U Installation Instructions 1 - Page 11

Dual Fuel appliance installation is complete when correct color, carryover and size are verified on each cooktop burner. For gas appliances, continue to "Test Broil Burner". Test Broil Burner Test Ignition Set cooking mode to Hi Broil. The burner will ignite after 30-75 seconds. Test Flame Verify that flame characteristics are as shown in Figure 4 "Checking Flame Characteristics". If flame characteristics are not consistent with those in the graphic above, adjust the flame as described below. Otherwise, continue to "Test Bake Burner". Test Bake Burner Test Ignition Set the oven to bake at 350° F (176.67°C). After 30-75 seconds, the burner will ignite. The burner will stay lit until the 350° F (176.67°C) is reached and then shut off. From this point forward, the burner will cycle on and off to maintain the temperature. Adjust Broil Flame (if necessary) Adjust the air shutter to alter the flame characteristics. The air shutter is located on the back end of the broil burner. 1. Loosen screw and turn shutter. Close the shutter if the flame is lifting or blowing or not carrying over; open the shutter if it is too yellow. (See Figure 5). Tighten screw. More Open: Less Yellow Flame Screw Air Shutter More Closed: Less Blue Flame More Carryover Less Lifting or Blowing Figure 5: Broil Air Shutter Adjustment English 8