Bosch HDI8056U Installation Instructions 1 - Page 9
Adjust Broil Burner Orifice, Adjust Bake Burner Orifice
View all Bosch HDI8056U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Adjust Broil Burner Orifice Adjust Bake Burner Orifice 1. Remove oven door (See section "Removing Oven Door" in Use and Care Manual). 2. Remove Broil Burner Assembly. The broil burner assembly is attached to the top of the oven cavity with 5 screws. Remove screws and gently pull broil burner assembly straight out being careful not to detach electrical wires. Place broil burner against back wall of oven cavity. 3. Use 1/2 inch (13 mm) wrench to remove the natural gas orifice and install the separate LP gas orifice provided. The orifice is located inside the oven cavity at the top right (visible with burner assembly removed.) The bake burner orifice is located below the air shutter (See Figure 3). Reach it through the access hole in the interior back panel of the warming drawer cavity. 1. Use a 1/2" wrench to turn orifice clockwise until it stops (2 1/2 - 3 turns). Unlike the broil burner orifice, the bake burner orifice should be tightened as far as it will go in order to ensure that complete conversion has occurred. Air Shutter Bake Orifice Figure 3: Bake Burner Orifice Adjustment 2. Use a Phillips head screwdriver to loosen the screw in the bake burner air shutter. Once loosened, turn the air shutter to its widest position (see figure below). Tighten the Phillips head screw in the air shutter. 4. Use a Phillips head screwdriver to loosen the screw in broil burner air shutter. Once loosen, take the LP conversion jig and place the THINNEST cylinder into the air shutter. Turn air shutter until it fits tightly against the pin. Tighten the Phillips screw in the air shutter and remove the LP conversion jig. DO NOT LEAVE LP CONVERSION JIG IN AIR SHUTTER Note: The air shutter on the broil burner fits over the orifice when installed correctly. English 6