Bosch HDI8056U Installation Instructions 1 - Page 6
Conversion
View all Bosch HDI8056U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Conversion Before You Begin Tools and Parts Needed • 7 mm Socket Driver w/ 3" extension • Torx (T20)-head screwdriver • Adjustable Wrench • Flathead Screwdriver (1/8" or smaller) • Phillips Head Screwdriver Parts Included • Conversion Kit Instructions • Conversion Sticker • 7 LP Orifices • 1 Broil Orifice Hood (models that are all gas only) • LP Conversion Jig (models that are all gas only) Note: This manual supports two different SIR models (dual fuel and gas), thus some parts listed may not be present if it doesn't pertain to the model purchased. General Information Always Provide Adequate Gas Supply This appliance is shipped from the factory for use with natural gas. Use this kit to convert the appliance for LP gas use if necessary. Observe the following: Be sure the range is converted for use with the appropriate gas before using it. This appliance is designed to operate at a pressure of 10" of water column when used with LP gas. When checking for proper operation of the regulator, the inlet pressure must be at least 1" greater than the operating (manifold) pressure above. When converting for LP gas use, the pressure supplied to the regulator must be between 11" and 14" of water column. The pressure regulator located in the inlet of the range manifold must remain in the supply line. Use a flexible metal appliance connector or rigid pipe to connect the Range to the gas supply. The connector should have an inner diameter of 1/2" and be 5' in length. (Exception: Maximum connector length in Massachusetts installations is 3'). In Canada, the connector must be single wall metal and not longer than 6'. Preparation CAUTION: Turn off Gas and Electricity Before proceeding with the conversion; shut off the gas supply to the appliance prior to disconnecting the electrical power. 1. Turn all control knobs to the "OFF" position. 2. Shut off the outside propane tank gas valve to the range. 3. Remove range power cord from electrical outlet or turn breaker off at breaker box. English 3