Bosch KBE-495V28-20N Instruction Manual - Page 15
Wiring Do's, Wiring Don'ts
View all Bosch KBE-495V28-20N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
KBE and KBN Series Installation | en 3 3.6.2 3.6.3 6. Attach the housing to the mount in accordance with the KBE and KBN Series Instruction Manual. Wiring Do's 1. Use point to point unshielded twisted pair wire, 24 AWG or thicker, stranded or solid, Category 2, 3, 4, or 5. 2. The video signal may coexist in the same wire bundle as other video, telephone, data, control signals, or low voltage power. 3. Measure the wire distance. Use only receivers designed for that distance. 4. Make sure the pair of wires carrying the video signal is sent as a twisted pair, not a split pair. Wiring Don'ts 1. DO NOT USE SHIELDED TWISTED PAIR WIRE, as this will severely degrade the distance performance. Short runs may be used with some signal degradation. Multi-pair wire with an overall shield is OK. 2. DO NOT USE UNTWISTED WIRE, as this will reduce the inherent immunity to interference. 3. DO NOT allow your installation to have bridge/ taps, loading coils, talk-battery, or MOV type protectors. Bridge taps refer to a twisted pair connected to two twisted pairs (such as an extension phone). Bridge taps cause reflections as the signal propagates, resulting in ghosts in the image. 4. If the phone company is providing the cable runs between buildings, make sure it is dry copper (i.e. it should have none of the following: dial tone, 48 V, loading coils, bridge taps, switching, or long paths to the phone company's central office and back). 5. Due to near-end cross talk, DO NOT send a transmit and receive signal in the same wire bundle. Exceptions: Less than 1000 ft (304.8 m), or Category 5 cable up to 609.6 m (2000 ft). 6. For safety, never put signals in the same conduit as high voltage wiring. Bosch Security Systems, Inc. Instruction Manual F01U065975 | 1.0 | 2007.04