Bosch SHE68E05UC Instructions for Use - Page 22

Problem Dishwasher not filling with water Water Leaks Tub stains Streaks on glassware or residue on the dishes Fascia panel discolored or marked Noise during wash cycle Cause Action 1. Restriction in the water supply system. 2. Previous wash cycle was not completed. 3. Delay-start is active. 1. Ensure that the water supply valve (typically located under kitchen sink) is open and check that the water supply line has no kinks and clogs. 2. Refer to the "Canceling or changing the cycle" section of this manual. 3. Cancel the delay-start or wait until delay-start time completes (times out). Refer to the "Delay Start" section of this manual. 1. Suds 2. Door seal could be pulled away from track. 3. Condensation vent is blocked. 4. Improper installation. 1. Wrong type of detergent results in suds and leaks. Use only dishwasher detergents. If suds still persist, then add one tablespoon of vegetable oil at the bottom of the dishwasher and run the desired cycle. 2. Ensure that door seal is in the track. 3. Ensure that condensation vent is not blocked. Refer to "Load- ing Extra Tall Items" in the Preparing and Loading the Dishwasher section of this manual. 4. Have proper installation verified by qualified personnel (water supply, drain system, leveling, plumbing). 1. Stains on the dishwasher interior are due to hard- 1. Concentrated Lemon juice can reduce the build up of hard ness of water. water stains. Run a normal cycle until it flushes and interrupt 2. Silverware in contact with tub. the cycle and then place an 8 oz. cup of the concentrated lemon solution on the top rack and finish the cycle. This can be done periodically to avoid build up. 2. Ensure that the silverware does not make contact with the tub while running a cycle. Incorrect rinse agent setting. Depending on the hardness of water, adjust the rinse agent dispenser. Refer to "Adding Detergent and Rinse Agent" section in this manual for adjustment. Abrasive cleaner used. Use mild detergents with soft damp cloth. The dishes may not be arranged properly. Water circulation sound is normal, but if you suspect items are banging into each other or into the spray arms, refer to the "Preparing and Loading" section of this manual for optimal arrangement. Detergent dispenser cover will not shut Unable to select desired cycle Error Codes Water is left in the appliance at the end of the programme 1. Improper operation of detergent cover. 1. Refer to "Adding Detergent and Rinse Aid" section of this man- 2. Previous cycle has not been finished, reset, or cycle ual for instructions on opening and closing the dispenser. was interrupted. 2. Refer to the "Canceling or changing the cycle" section of this manual. Previous cycle has not finished or another cycle has already started. Refer to the "Canceling or changing the cycle" section of this manual. If fault code (E01 to E30) is indicated on the digital display 3 , first disconnect the appliance from the power supply. You can rectify certain faults yourself (see following fault description), for all other faults please contact customer service and state the indicated fault E:XX. 1. (E24) Waste water hose is blocked or kinked. 2. (E25) Waste water pump blocked, cover on the waste water pump is not locked in position 3. Filters blocked. 4. The programme has not yet ended. 1. See Care and Maintenance. 2. Wait until programme ends (digital display indicates 0:00) or implement the "Reset"function. 21