Bosch SHE68E05UC Instructions for Use - Page 7

•Dishwasher setup Water softening system Your dishwasher requires soft water to ensure proper washing results and is equipped with an internal water softening system. However, if you have a household water softening system, you will not need to use the internal system provided. tap set value use water hardness at The amount of salt required depends on the degree of hardness of your tap ppm CaCO³/l dishwasher salt water (see table at right for more information). 0 - 110 H:00 no For the water softening system to function properly, it will need to use 120 - 140 H:01 yes dishwasher water softener salt. The amount of salt dispensed can be set from 150 - 180 H:02 yes "H:00" to "H:07". Salt is not required at H:00 (this is the default factory 190 - 210 H:03 yes setting - see table at right). 220 - 290 H:04 yes • Open the door (for hidden controls only). • Turn the unit on using the [ON/OFF] button . 300 - 370 H:05 yes 380 - 540 H:06 yes 550 - 890 H:07 yes • Hold down the "A" button (see page 4) and press [START] until the Default setting from factory is H:00 display indicates "H:00". • Release both buttons. • Press the "B" button to select the desired setting. • Save the selected setting by pressing [START]. • Close the door (for hidden controls only). NOTE: For information on how to use the water hardness test strip, provided in the detergent sample kit, please see below. Using a water hardness test strip Establishing the water SSeettttiinngg ooff hardness wateWr saotfetrener Fill with Salt Dip the test strip briefly into tap water for a second. SDhipakberioefflfyetxhceetsesswt sattreipr ainntdo ctaopmwpaatreeraffotreor naepproximseactoenlyd1, smhainkueteof.f excess water compare after 1 min. daAaAdirfrseftieectcaeoarosrsllooow1nwrraiameliltltlimisioosnhnhniuonotouwoewftfettytyhhhotoeheeuuetrteteterhhsedseetdt ccoorrrreecctt sseettttiinngg.. Alignment of Softening Fill salt into the salt Unit container 0 H:000 no 1 H:000 no 2 H:202 yes 3 H:404 yes 4 H:606 yes 6