Bosch SHE68E05UC Installation Instructions - Page 12

~1/2″ (12mm) WARNING Avoid Tip Over Hazard Do not use the dishwasher until it is completely installed. When opening the door on an uninstalled dishwasher, carefully open the door while supporting the rear of the unit. Failure to follow this warning can result in serious injury. LEVELING THE DISHWASHER The unit should now be ready to slide into the cabinet opening. To avoid scratching the floor, use floor protection and caution when sliding the dishwasher into the cabinet. Make sure that the hoses and cords do not bunch up behind the unit or kink as you slide the unit back. Make certain to slide the unit into place before raising the leg levelers. Level the dishwasher horizontally by turning feet clockwise to raise or counter-clockwise to lower front of the unit. Level the dishwasher vertically by turning center screw to raise or lower the back. Figure 17 Figure 18 For Top Mount - Wooden 1/16″ (2mm) D Figure 19 For Side Mount - Stone Countertop D ~1/2″ (12mm) Figure 20 For Alternate Side Mount 1/16″ (2mm) SECURING THE DISHWASHER 1. Drive the mounting screws through the holes in the N mounting brackets as shown for Top (Figure 18), Side Mount (Figure 19) and Alternate Side Mount (Figure 20). 2. After the unit is installed in the enclosure, leveled and secured, lock the two front leg levelers in place by driving the enclosed leg leveler locking screws into each screw boss located in front of the levelers. 3. Tighten screws until they are flush with the surface of the bosses. 11