Bosch SHX68T55UC Instructions for Use - Page 23

Problem, Cause, Action - heated dry

Get Bosch SHX68T55UC PDF manuals and user guides View all Bosch SHX68T55UC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Problem Cause Action Streaks on glassware or residue on the dishes 1. Incorrect rinse aid setting 1. Depending on the hardness of water, adjust the rinse agent dispenser. Refer to "Adding Detergent and Rinse Aid" section in the manual Dishes are not getting dry enough 1. Rinse aid dispenser is empty 2. Improper loading of dishes Note: Plastic or Teflon do not typically dry as well as other items due to their inherent properties. 1. Add rinse aid - the use of rinse agent improves drying, use the Auto cycle, use the Sanitize option. 2. Rearrange load to ensure items are not nesting (see "Loading the Dishwasher" section of the manual) Note: Select models offer an extra heating option to improve drying performance. Odor 1. Food debris is present at the bot- 1. Remove the filters and clean accord- tom of the dishwasher ing to the "Care and Maintenance" sec- 2. Food particles are present near tion of the manual the door seal 2. Refer to "Care and Maintenance" sec- 3. Residual water is present at the bot- tion of the manual tom of the dishwasher 3. Ensure the unit has completely 4. Drain hose is obstructed drained from the last cycle 4. Remove any obstructions from the drain hose by calling qualified personnel. Note: If odor still persists, run the Nor- mal/Regular cycle until it flushes and interrupt the cycle and place an 8oz. cup of distilled white vinegar solution on the top rack and then finish the cycle. Dishwasher not filling with water or "Check water supply" display lights up 1. Restriction in the water supply 1. Ensure that the water supply valve system (typically located under kitchen sink) 2. Previous wash cycle was not com- is open and check that the water sup- pleted ply line has no kinks or clogs 3. Delay start is active 2. Refer to the "Operating the Dish- 4. Household water supply turned off washer" section of the manual 3. Cancel the delay start or wait until delay start time completes 4. Turn on water supply Fascia panel 1. Abrasive cleaner used discolored or marked 1. Use mild detergents with soft damp cloth Noise during wash cycle 1. Dishes may not be arranged properly 1. Water circulation sound is normal, but if you suspect items are banging into each other or into the spray arms, refer to the "Loading the Dishwasher" section of the manual for optimal arrangement. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
22
Streaks on
glassware
or residue
on the
dishes
1. Incorrect rinse aid setting
1. Depending on the hardness of
water, adjust the rinse agent dis-
penser. Refer to “Adding Detergent
and Rinse Aid” section in the manual
Dishes are
not getting
dry enough
1. Rinse aid dispenser is empty
2. Improper loading of dishes
Note: Plastic or Teflon do not typically dry
as well as other items due to their inher-
ent properties.
1. Add rinse aid - the use of rinse agent
improves drying, use the Auto cycle, use
the Sanitize option.
2. Rearrange load to ensure items are
not nesting (see “Loading the Dish-
washer” section of the manual)
Note: Select models offer an extra heat-
ing option to improve drying perfor-
mance.
Odor
1. Food debris is present at the bot-
tom of the dishwasher
2. Food particles are present near
the door seal
3. Residual water is present at the bot-
tom of the dishwasher
4. Drain hose is obstructed
1. Remove the filters and clean accord-
ing to the “Care and Maintenance” sec-
tion of the manual
2. Refer to “Care and Maintenance” sec-
tion of the manual
3. Ensure the unit has completely
drained from the last cycle
4. Remove any obstructions from the
drain hose by calling qualified personnel.
Note: If odor still persists, run the Nor-
mal/Regular cycle until it flushes and
interrupt the cycle and place an 8oz. cup
of distilled white vinegar solution on the
top rack and then finish the cycle.
Dishwasher
not filling
with water
or “Check
water sup-
ply” display
lights up
1. Restriction in the water supply
system
2. Previous wash cycle was not com-
pleted
3. Delay start is active
4. Household water supply turned off
1. Ensure that the water supply valve
(typically located under kitchen sink)
is open and check that the water sup-
ply line has no kinks or clogs
2. Refer to the “Operating the Dish-
washer” section of the manual
3. Cancel the delay start or wait until
delay start time completes
4. Turn on water supply
Fascia panel
discolored
or marked
1. Abrasive cleaner used
1. Use mild detergents with soft
damp cloth
Noise dur-
ing wash
cycle
1. Dishes may not be arranged
properly
1. Water circulation sound is normal, but
if you suspect items are banging into
each other or into the spray arms, refer
to the “Loading the Dishwasher” section
of the manual for optimal arrangement.
Problem
Cause
Action