Bosch WAW285H2UC Instructions for Use - Page 15
Water connections
View all Bosch WAW285H2UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3. Place covers over the transport bolt holes. Four plastic covers are provided in the small parts bag included with your washer. Separate these covers and install one in each hole where the transport bolts were removed. Lock covers firmly by pressing on the snap hook. NOTICE: Keep the assemblies together and store them for later use such as when moving the washer. ▯ The water supply pressure must be between 14.5 to 145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons (8 liters) of flow per minute. A pressure regulator valve must be installed if the maximum water pressure is exceeded. ▯ Make sure the water supply faucet is easily accessible when the washer is in use. The faucet should be turned off if the washer is going to be unused for extended periods of time. ▯ Make sure rubber washers are in place at both ends of the water supply hose. Missing washers could cause leaks. ▯ The connection points are under full water pressure. Turn on the water tap and check for leaks. ▯ Periodically inspect the water supply hose and replace with a new hose if cuts, kinks or leaks are observed. Water connections Water supply hose connections NOTICES ▯ The washing machine must only be operated with cold and hot (max. 140 °F/60 °C) tap water. Do not connect the appliance to the mixer tap of a pressurized hot-water boiler. ▯ To prevent water damage, the hot and cold water valves should be accessible when the washing machine is in place and should always be turned off when the washing machine is not in use. ▯ If installing the washing machine in a new building or a building in which the plumbing system was recently installed or upgraded, flush the lines before installing the washing machine to remove any sand, dirt or residue. ▯ To prevent leakage or water damage, follow the instructions in this chapter. ▯ If in doubt, have the appliance installed by an authorized technician. Connect your washer to the wall faucets using the included AquaShield® water supply hose. Observe each of the following: ▯ Only use the new water supply hose shipped with your washer. Never use old used hoses. ▯ The water supply hoses must not be kinked, bent, or pinched causing hose damage or restricting water flow. Water connection hoses ▯ red - Hot water-hose ▯ blue - Cold water-hose PD[ PD[ Attach this end to water tap. Hand tighten only. Attach this end of the hose to the back of the washing machine as shown in the following pictures. Be sure to use clamps and route hoses as instructed. Hand tighten only. 15
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48