Bosch WAW285H2UC Instructions for Use - Page 36
Optional program settings
View all Bosch WAW285H2UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Optional program settings At the factory, temperature and spin speed options, and cycle duration ("Finish in" time) are pre-set for all cycles. After selection of the cycle, these values are displayed in the display field. EcoPerfect Energy optimised washing by reducing the temperature while achieving a washing result that is consistent with the selected program, without the EcoPerfect setting. Prewash For heavily soiled washing. Pour 1/3 of normal detergent amount into pre-wash chamber I and remaining 2/3 into main wash chamber II. Rinse Plus This feature adds additional rinses to selected program which is helpful for locations with soft water supplies or to generally improve rinsing results. It will increase the program duration. Remote Start Briefly pressing the Remote Start button activates or deactivates the Remote start function. Activating the Remote start function enables the appliance to be started remotely via the Home Connect app. NOTICES ▯ Remote start can only be activated if the appliance door is closed and the appliance is connected to your home network. ▯ Remote start will be deactivated in the following circumstances: ▯ The door is opened. ▯ There is a power failure. ▯ The Remote Start button was briefly pressed again deactivating it. ▯ The center of the Program Selector was pressed switching off the appliance. ▯ Once the program has ended. ▯ A program was not started within a 24 hour period after activating the Remote start function. ▯ Any button was pressed or the program selector was turned on the control panel. Pressing and holding the Remote Start button for at least 3 seconds enters Home Connect settings. Finish in The program end (Finished in) time can be set in one hour increments to a maximum of 24 h (hours). After selecting the desired washing program (at the dial) but before pressing the Start/Pause button, press the Finish in button until the desired time is displayed, e.g. 8 h. Press the Start/Pause button to start the washer. NOTICE: The cycle duration is included in the set Finish in time. Here is an example of a 1hr:30min cycle time and an 8 h Finish in time. 8 h is displayed (until the Energy-saving mode activates) and counts down (approximately 6hr:30min) until the washing cycle begins (at 1hr:30min) then the cycle duration 1:30 is displayed and began. Total time approximately 8 hours. Spin Speed Before and during the cycle, you can change the spin speed range depending on the cycle progress. Touch the appropriate button until the desired setting is displayed. No Spin: This option eliminates the final spin and the load remains saturated with the final rinse water. The pump is activated to remove all residual water. ~ Program selection table; Page 34 Temperature Before and during the cycle, you can change the default temperature range depending on the cycle progress. Press the appropriate button until the desired setting is displayed. The maximum temperature range that can be set depends on the cycle selected. ~ Program selection table; Page 34 SpeedPerfect For washing in a shorter time with a washing result comparable to that of the standard program. NOTICE: Do not exceed the maximum load. ~ Program selection table; Page 34 Stains There are four types of stain to choose from: Ê Oils, food based ¶ Blood º Red wine · Grass The washer adjusts the average washing temperature, drum movement and soaking time to the specific type of stain. Hot or cold water, gentle or intensive washing and long or short soaking ensure that the wash-program sequence is specially adapted to each type of stain. This makes sure that stains are treated in the best possible way. NOTICE: Pressing and holding the button automatically runs through the set values. 36