Bose Aviation Headset Series II Owner's guide - Page 16
Panel Hole Required, Aircraft Interface Schematic, Receptacle - Pinout Front View
View all Bose Aviation Headset Series II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Using the Bose® Aviation Headset 5. Approved adhesives for use with this connector are Ciba-Geigy Uralane 5754A/B, Lord 710, or VTCS-6 Vibratite. Do not let any cyanoacrylate-based adhesives (e.g., Loctite), flux remover, or other caustic compounds come into contact with the installed connector body. These chemicals will cause deterioration and/or irreparable damage to the connector. For information on chemical compatibility and connector part number, contact LEMO USA, Santa Rosa, CA at 1-800-444-5366. Figure 9 Connector technical information PANEL HOLE REQUIRED 12.6mm .5" 14.1mm .56" RECEPTACLE - PINOUT (FRONT VIEW) PIN 1 PIN 6 AIRCRAFT INTERFACE SCHEMATIC RED BLK BLK WHT BLK WHT WH/BLU BLK • 1 V+IN • 2 GND • 3 COMM L • 4 COMM R • 5 MIC HI • 6 MIC LO 16