Brother International 7160C Users Manual - English - Page 117
Remote Control Commands, MFC and enter your Remote Access Code 159
UPC - 012502563631
View all Brother International 7160C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
102 C H A P T E R T W E L V E Remote Control Commands Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (159 ), the system will signal you with two short beeps to enter a remote control command. Remote Control Commands Details Operation 91 Playing voice messages After one long beep, the MFC plays ICMs and Memos. 1 (Skip back) 2 (Skip next) 9 Stop Playing 92 Record Memo 93 Erase all ICM & Memo 94 Play and Record OGM in memory 1 Play 1 MSG CTR OGM 2 F/T OGM 2 Record 1 MSG CTR OGM 2 F/T OGM 95 Changing Fax Forwarding/ Paging setting 1 OFF 2 Fax Forwarding 3 Paging 4 FAX FWD NO. 96 Retrieve Fax 1 Memory Status List 2 Retrieve all FAX 3 Erase FAX in the memory Press 1 while listening to an ICM or Memo message to play it again. If you press 1 before a message, you will reply the previous message. While playing an ICM or Memo, you can skip to next message. Stop playing the ICM and Memo. After one long beep, you can record a memo. You can stop recording by pressing 9. If you hear one long beep, the erase is accepted. If you hear three short beeps, you cannot erase because all voice messages have not been played, or there is no voice message to erase. *This code erases all recorded messages, not one at a time. The MFC plays the selected OGM. You can stop playing OGMs by pressing 9. After one long beep, you can record the selected OGM. Your recorded message will be played when you finish speaking. You can stop recording the message by pressing 9. If you hear one long beep, the change is accepted. If you hear three short beeps, you cannot change it because the conditions have not been met (Example: registering paging number). You can register your fax forwarding number by using 4. FAX FWD NO (see page 104). Once you have registered the number, the MFC will automatically change to "FAXFWD:ON" mode. Then retrieve a Memory Status List by entering 961 (see page 103) to make sure that the Fax Forwarding number you registered is correct in the List. Enter the number of a remote fax machine to receive a report or stored fax messages. (See page 103.) If you hear one long beep, you can erase the fax message from the memory. 97 Check the receiving status 1 FAX 2 VOICE 98 Change Answer Mode 1 MSG CTR 2 FAX/TEL 3 FAX 90 Exit You can check whether your MFC has received any FAX or VOICE messages. If yes, you will hear one long beep. If no, you will hear three short beeps. If you hear one long beep, you can change the answer mode. If you hear three short beeps, you cannot change it (For example: When there is no MSG CTR OGM and you tried to change to MSG CTR mode.) After a long beep, you can exit remote control.