Brother International BAS-311E Network Users Manual - English - Page 66
Adjusting the lowest point of the presser foot
View all Brother International BAS-311E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Chapter 4. Adjustments 8. Adjusting the lowest point of the presser foot 1. Turn the pulley to align the needle bar with the shuttle hook. At this time, turn the stepping work clamp con- necting rod q to turn stepping work clamp arm F w in the direction of the arrow, and move the stepping link w o assy e in the direction of the arrow. When the presser foot is at the lowest position, secure the stepping work clamp connecting rod q to the upper shaft t using the i set screw r. Adjust the lift stroke of the presser foot to 3 - 5 mm, and e 5 - 8 mm. When the clearance between the presser bar lifter y and the presser bar bush u is 0.5 - 1 mm, tighten the bolt of stepping work clamp arm F w. (At this time, the match mark i of stepping work clamp arm F w will y be almost aligned with that of arm mark o.) Note: Make sure that stepping work clamp arm F w has 0.5 - 1mm no end play. !6 u !1 !0 r q t !5 !4 !2 2. Attach the needle to the needle bar. 3. Turn the pulley to insert the needle !2 into the hole of the presser foot !4. Turn the presser bar !5 so that the needle !2 is in the center of the hole of the presser foot !4, and tighten the screw of the needle bar clamp !6. 58 BAS-311E.311EL.326E.326EL