Brother International BES-961BC Instruction Manual - English - Page 44
Adjustment], Loosen the right and left bolts of the F table guide U
View all Brother International BES-961BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Chapter 1 Preparation of Embroidery Machine 6. Check that the clearance between the Y-axis cover u and the mounted holder base frames L e and R t is even when viewed from the right and left sides. [Adjustment] Loosen the right and left bolts of the F table guide U i and move it in the direction of arrow for adjustment. 7. Tighten each bolt securely after adjustment is finished. Attaching the holder base 1. Mount the holder base mounting frame e on the X-axis feed frame q and holder base frame C w, using three clamp screws. 2. When the mounting pitch of the holder base is 370 mm, mount the holder base horizontally to the holder base mounting frames e using the thumb bolts r. q r e w 42 BES-961BC • BES-1261BC
Chapter 1
Preparation of Embroidery Machine
BES-961BC
•
BES-1261BC
42
6.
Check that the clearance between the Y-axis cover
u
and the mounted holder base frames L
e
and R
t
is even when viewed from the right and left sides.
[Adjustment]
Loosen the right and left bolts of the F table guide U
i
and move it in the direction of arrow for
adjustment.
7.
Tighten each bolt securely after adjustment is finished.
Attaching the holder base
1.
Mount the holder base mounting frame
e
on the X-axis feed frame
q
and holder base frame
C
w
, using three clamp screws.
2.
When the mounting pitch of the holder base is 370 mm, mount the holder base horizontally to
the holder base mounting frames
e
using the thumb bolts
r
.
w
e
r
q