Brother International BES-961BC Instruction Manual - English - Page 47
Bed Retract, to the right
View all Brother International BES-961BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Chapter 1 Preparation of Embroidery Machine 4-5 Bed Retract When embroidery within the maximum area by mounting the tubular square hoop, there is a possibility that the hoop interferes with the bed. Retract the bed of several machine heads to avoid interference. Machine heads with an even number enter a halt status. Note) The machine heads are numbered 1 ~ 6 from the right side. This figure shows an example of BES-961BC. Refer to the same sections for BES-1261BC. q e w No.6 No.4 No.2 r 1. Loosen two bolts w that secure the bed support q, and move the bolts w to the right and left. Note) • The bed is secured by two bolts and supported at three places. • When loosening the bolts, support the bed by hand. 2. Lower the machine bed e slowly until it comes into contact with the leg. 3. Tighten the bolts w again. BES-961BC • BES-1261BC 45