Brother International DCP 585CW Quick Setup Guide - English - Page 27

For Wireless Network Users Connecting the Brother machine to the wireless network Important You must have the wireless setting you wrote down for your network in step 11 on page 26 before you proceed. 12 Configure the wireless settings (Typical Wireless Setup in infrastructure mode) a On your machine, press Menu. Press a or b to choose Network and press OK. Press a or b to choose WLAN and press OK. Press a or b to choose Setup Wizard and press OK. When Network I/F switched to Wireless is displayed, press OK to accept. This will start the wireless setup wizard. To cancel, press Clear/Back. b The machine will search for available SSIDs. If a list of SSIDs is displayed, use the a or b keys to choose the SSID you wrote down in step 11 on page 26, then press OK. Go to f. Note It will take several seconds to display a list of available SSIDs. If your access point is set to not broadcast the SSID you will have to manually add the SSID name. Go to c. c Press a or b to choose and press OK. Go to d. d Enter the SSID you wrote down in step 11 on page 26 using the a, b keys to choose each letter or number. You can use the d and c keys to move the cursor left and right. For example, to enter the letter a, press the a key once. To enter the number 3, hold down the a key until it appears. The letters appear in this order: lower case, upper case, numbers and then special letters. (For more information, see Entering Text for Wireless Settings on page 42.) e Press a or b to choose Infrastructure, then press OK. f Use the a, b and OK keys to choose one of the options below: If your network is configured for Authentication and Encryption you must match the settings used for your network. „ No Authentication or Encryption: Choose Open System, press OK then choose None for Encryption Type? and press OK. Then press settings. Go to i. Yes to apply your „ No Authentication with WEP Encryption: Choose Open System, press OK then use the a or b to choose WEP for the Encryption Type? and press OK. Go to g. „ Authentication with WEP Encryption: Choose Shared Key and press OK. Go to g. „ Authentication with WPA/WPA2-PSK (TKIP or AES) Encryption: Choose WPA/WPA2-PSK and press OK. Go to h. g Press a or b to choose the appropriate key number and press OK. Enter the WEP key you wrote down in step 11 on page 26 using the a, b keys to choose each letter or number. You can use the d and c keys to move the cursor left and right. For example, to enter the letter a, press the a key once. To enter the number 3, hold down the a key until it appears. The letters appear in this order: lower case, upper case, numbers and then special letters. (For more information, see Entering Text for Wireless Settings on page 42.) Press OK when you have entered all the characters, then press settings. Go to i. Yes to apply your Press OK when you have entered all the characters. 27 Wireless Network