Brother International DreamWeaver„ VQ3000 Sewing End Point 1.05 or Later - Page 4

■ Reusing the Previous Setting When using the same fabric and pattern to sew the same length, the previous setting can be used again, instead of using the sensor pen to specify the sewing end point each time. To use the previous setting, repeat steps c through e then press sensor pen. in step f, instead of using the * If was pressed, it is unnecessary to specify the sewing end point for the second time. Continue with step j to continue sewing until the machine automatically stops at the sewing end point. * Be sure to press to begin sewing at the beginning of the stitch pattern. Note • This resume function will only repeat the sewing distance that has been assigned within the 200 mm (approx. 8 inches) distance from the needle point to the sewing end point. If you are already sewing and you stop the machine to specify the ending point, when pressing to duplicate the previous setting the machine will only repeat the distance from where you stop the machine to the ending point. You can change the sewing end point after pressing by touching the new end point with the sensor pen. For better result, however, it is rather recommended to specify the end point again from the beginning. • The sewing end point cannot be recalled in the following situations. (The key is not available.) - When the machine has been turned off. - When a pattern is changed, added or deleted. - When the stitch length is changed. - When a pattern is flipped vertically. - When the dual feed foot is attached/detached. - When the feed position lever of the dual feed foot is raised/lowered. • To cancel the previous setting, press . Continue the procedure from step f. • The sewing end point can be recalled; however, if the sewing conditions have changed, for example, different fabric is used, the sewing end point must be specified again from the beginning. 4 XF5842-001