Brother International Innov-is 4750D Software Users Manual/4.0 Operation Manua - Page 16

m Thread the machine with the thread for the outline from step o, and then sew the placement line for the appliqué position (APPLIQUE POSITION). q Use scissors to cut the excess water-soluble stabilizer from outside the appliqué outline. r Soak the appliqué piece in water to dissolve the water-soluble stabilizer. fi a Pattern placement line n Lightly apply glue or spray adhesive, and paste the appliqué piece so that it aligns with the placement line. s Dry the appliqué piece, and then iron it if necessary. Note • Do not apply a strong force when ironing, otherwise the stitching may be damaged. ■ Using a Frame Pattern for the Outline Using a frame pattern, the desired shape can be added as the outline of the appliqué. Note • Before pasting the appliqué piece down, make sure the appliqué piece is positioned correctly within the placement line. o With the machine threaded using the thread for the outline from step m, sew the outline (APPLIQUE). a Perform the operations described in steps a through e of "Creating an Appliqué Piece". b Select the desired frame shape and pattern, and add it to the appliqué pattern. a Outline of appliqué piece Memo • The outline is sewn using satin stitching. • Some glue may get onto the presser foot, needle, and needle plate at this time. Finish embroidering the appliqué pattern, and then clean off the glue. p After embroidering is finished, remove the stabilizer material from the embroidery frame. 15