Brother International Innov-is 4750D Software Users Manual/4.0 Operation Manua - Page 7

b Affix stabilizer material to the fabric to be embroidered. Note • When embroidering the edges of the fabric, affix stabilizer material larger than the fabric, and then firmly secure the fabric and excess part of the stabilizer material within the border embroidery frame (in the same way as when the normal embroidery frame is used). Otherwise, misaligned patterns may result. e Place the embroidery sheet in the upper frame, align the guide line on the embroidery sheet with the mark (line) on the fabric, and then press down on the left and right locking levers until they click into place. a Fabric b Stabilizer c If the upper frame is locked down against the lower frame, press the left and right lock release buttons to unlock the upper frame. a Locking levers Memo • The fabric can also be positioned in the border embroidery frame by aligning the edge of the fabric with the inner markings on the upper frame. a Lock release buttons d Lay the fabric between the upper and lower frames. Note • If there is excess fabric after the center of the embroidering area is aligned with the center of the border embroidery frame, fold over the excess fabric, place it on top of the upper frame, and then press down on the levers. Be careful that the folded excess fabric is not caught in the embroidering area. f Remove the embroidery sheet, and then pull the four sides of the fabric to remove any slack. Finally, check that the fabric is firmly stretched. 6