Brother International Laura Ashley Innov-is NX800 Users Manual - English - Page 81
After adjusting the stitch width, slowly
View all Brother International Laura Ashley Innov-is NX800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Raise the presser foot lever to check that the f side cutter is securely attached. Pass the upper thread under the side cutter, g and then pull it out toward the rear of the sewing machine. Position the fabric in the side cutter. j The cut in the fabric should be positioned over the guide plate of the side cutter. a a Guide plate • If the fabric is not positioned correctly, the fabric will not be cut. Select a stitch. h Lower the presser foot lever, and then start k sewing. 3 • For details, refer to "Selecting stitching" (page 72). CAUTION ● After adjusting the stitch width, slowly turn the handwheel toward you (counterclockwise) and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break. Make a cut of about 2 cm (3/4 inch) long in i the fabric at the beginning of the stitching. X A seam allowance is cut while the stitching is sewn. • If the stitching is sewn in a straight line, the seam allowance will be about 5 mm (3/16 inch). 1 1 a 2 cm (3/4 inch) a 5 mm (3/16 inch) Memo z The side cutter can cut as much as one layer of 13-oz. denim. z After using the side cutter, clean it by removing any lint or dust. z If the side cutter can no longer cut fabric, use a rag to apply a small amount of oil to the cutting edge of the cutter. Overcasting Stitches 79