Brother International MFC 9060 Service Manual - Page 74
EL (Eraser Lamp) Board, Refer
UPC - 012502040064
View all Brother International MFC 9060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
1.22 EL (Eraser Lamp) Board Only when you need to replace the EL board (which is attached with double-sided adhesive tape), remove it according to the steps below. (1) Make sure that the EL board harness is disconnected from the high-voltage power supply PCB. (Refer to Section 1.15.) (2) Make sure that the heat-fixing unit is removed. (3) Peel off the EL board from the main cover and clear adhesive tape if remaining. Reassembling Notes • When attaching a new EL board, bring the right end into contact with the boss provided on the main cover. IV - 42
IV
- 42
1.22
EL (Eraser Lamp) Board
Only when you need to replace the EL board (which is attached with double-sided adhesive tape),
remove it according to the steps below.
(1)
Make sure that the EL board harness is disconnected from the high-voltage power supply PCB.
(Refer to Section 1.15.)
(2)
Make sure that the heat-fixing unit is removed.
(3)
Peel off the EL board from the main cover and clear adhesive tape if remaining.
±
Reassembling Notes
•
When attaching a new EL board, bring the right end into contact with the boss provided on the
main cover.