Brother International PR-1000 Table Set Installation Manual PRWT1 - Page 5
Removing the table
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Removing the table Loosen the two thumb screws, lift up the 1 table, and then pull it off toward you. After the pins on each side reach the notches 3 in the guide plates, raise the table to lift the pins up through the notches. 1 Thumb screw Carefully pull out the table so that it does 2 not hit the machine. 1 Pin 2 Notch X Remove the table from the machine. Slightly tighten the thumb screws on the 4 table to prevent loss. 4/4
4/4
—————————————————————————————————————————————————————————————————————————————————————
Removing the table
1
Loosen the two thumb screws, lift up the
table, and then pull it off toward you.
1
Thumb screw
2
Carefully pull out the table so that it does
not hit the machine.
3
After the pins on each side reach the notches
in the guide plates, raise the table to lift the
pins up through the notches.
1
Pin
2
Notch
X
Remove the table from the machine.
4
Slightly tighten the thumb screws on the
table to prevent loss.