Canon PIXMA MP640 Network Setup Troubleshooting - Page 9

Reference Information Entering the Access Point's Wireless LAN Settings Directly on the Machine Action Enter the access point name/network name (SSID) and security setting (WEP, WPA, etc.) on the machine directly. Follow the procedure below. 1 Use the Easy-Scroll Wheel to select Settings, then press the OK button. 2 Select Wireless LAN setup, then press the OK button. 3 Select Yes, then press the OK button. • When wireless connection is enabled, the Wi-Fi lamp lights blue. 4 Select Easy settings, then press the OK button. 5 Select Directly enter the access point name, then press the OK button. • If you are living in an apartment, nearby access points in use may be detected. 6 Enter the access point name/network name (SSID) using the Easy-Scroll Wheel, then press the OK button. Use the Easy-Scroll Wheel to select the character. Use the ] button to move the cursor to the right. • Enter the same access point name/network name (SSID) as that of the access point on the machine. • For details on how to check the access point name/network name (SSID), refer to the manual supplied with the access point or contact its manufacturer. • Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive. 7 Select a security protocol for the access point, then press the OK button. • Go to either of the following steps according to the selected security protocol. Disable WEP WPA/WPA2 • When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select WEP (64 bit). • When WEP (Transitional Security Network) is selected in AirPort Utility, select WEP (128 bit) or WPA2-PSK (AES).