Canon imageCLASS D420 imageCLASS D480 Starter Guide - Page 11

Connect Power Cord and Turn On the Machine - software

Get Canon imageCLASS D420 PDF manuals and user guides View all Canon imageCLASS D420 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Connect Power Cord and Turn On the Machine 1 Connect the power cord into the rear socket on the back side of the machine and the wall outlet, and press the [I] side of the main power switch (A) to turn ON. 2 Set Up the Machine Do not connect the machine and the computer with a USB cable at this time. Connect the machine and the computer with a USB cable only during the software installation procedure. (A USB cable is not used when the machine is used via a network connection.) 2 The machine enters the standby mode. 100% LTR TEXT/PHOTO 1 ● The LCD display turned OFF: The machine may enter the Sleep mode while you are performing setup. Press [Energy Saver] to turn the display back ON and continue the setup. ● is displayed: Make sure that the toner cover and scanning platform are closed properly. (See "Install Toner Cartridge," on p. 4.) ● is displayed: Check the installation of the toner cartridge and the placement of the paper. (See "Install Toner Cartridge," on p. 4 and "Set Up Paper Cassette and Load Paper," on p. 7.) 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
9
2 Set Up the Machine
Connect Power Cord and Turn On the Machine
1
Connect the power cord into the rear socket on
the back side of the machine and the wall
outlet, and press the [I] side of the main power
switch (A) to turn ON.
Do not connect the machine and the computer with a USB
cable at this time. Connect the machine and the computer
with a USB cable only during the software installation
procedure. (A USB cable is not used when the machine is
used via a network connection.)
2
The machine enters the standby mode.
TEXT/PHOTO
1
100%
LTR
The LCD display turned OFF:
The machine may enter the Sleep mode while you are performing setup. Press
[Energy Saver] to turn the display back ON and continue the setup.
<SET PAPER AGAIN/SET TONER AGAIN> is displayed:
Make sure that the toner cover and scanning platform are closed properly. (See
“Install Toner Cartridge,” on p. 4.)
<CLOSE COVER/TONER COVER> is displayed:
Check the installation of the toner cartridge and the placement of the paper.
(See “Install Toner Cartridge,” on p. 4 and “Set Up Paper Cassette and Load
Paper,” on p. 7.)
●
●
●