Casio DT-X10 User Guide - Page 59
Using CF Card Extension Unit
UPC - 079767602307
View all Casio DT-X10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Using CF Card Extension Unit The CF Card Extension Unit (DT-894CFU) supports use of Compact flash (CF) Type I cards and Type II cards (3.3/5.0V). Bundled Item DT-894CFU Protector Large Card Cover Attach to the connector part. 4 screws Use the procedure below to load and remove CF cards. Use this cover when you have a data communication card or other large card installed in the card slot. Important! • Installing some cards will make it impossible to close the card slot cover. When that happens, you can either use the Large Card Cover or you can use the Handheld Terminal and CF card without a card slot cover. Keep the card slot cover in a safe place where you will not lose it. Note that the Handheld Terminal is not water resistant while its card slot cover is removed . Exercise special care when using the Handheld Terminal without its card slot cover attached. • When using a CF storage card, be sure to close the card slot cover. Attaching the CF Card Extension Unit Attach the CF Card Extension Unit to the back of the Handheld Terminal. The CF Card Extension Unit connector is located under a protective cover. 1. Loosen two screws and detach the protector from the connector. 2. Attach the CF Extension Card Unit after peeling off the seals (2) on the back, and then firmly secure it by fastening all the way down on the back of the Handheld Terminal with the screws 1, 2, 3 and 4 provided. Although screws 3 and 4 may be particularly difficult to insert, make sure they are inserted all the way in. 2 4 1 3 DT-X10_E_P53_59.p65 57 2005.4.20, 3:47 PM E-57