Cisco AIR-AP1010 Quick Start Guide - Page 22
Projection Wall Mount
UPC - 882658154027
View all Cisco AIR-AP1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Mounting the Access Points Installation and Configuration Projection Wall Mount When you are mounting the AP out from a wall (flat sides along the wall or hallway), use an optional factory-orderable projection-mount L-bracket. 1. Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom of the AP. Be sure the spring washers have their convex (high center sections) pointing toward the screw heads. Note The AP threaded holes have precision-depth threads. Do not overtighten the screws, or the bracket will not fit under the screw heads. Figure 7 Attaching the Mounting Screws and Spring Washers to the AP 135667 A. Screws and spring washers B. Completed assembly 2. Copy the MAC address(es) from the label(s) on the AP onto the corresponding location on the map. MAC addresses have the format 00xxxxxxxxxx. 3. You have already attached the projection-mount L-bracket to the wall in "Mounting the Access Points". 4. Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure. Note If the screws do not securely hold the bracket, remove the AP and adjust the screws until they securely hold the bracket. AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal 10 7817146-01